![]() Strike plate and screw-in anchors or fasteners Step 1 – Measure and Mark Your Holeįirst, you need to measure the front door jamb, which is part of the doorway that extends vertically above the entrance.For more information, please follow these steps. A few tabs are welded into a recess on commercial doors to ensure flush mounting.Ī better option would be to pull out the frame and weld the tabs in. It’s possible to simply put the deadbolt strike on the metal door jamb if there is enough space. Installing A Strike Plate On Metal Door Frame | Step By Step Keeping them below the surface of steel jambs will enable them to sit flat on striker plates. Two holes should be drilled directly in line with the dimples. Metal doors can be affected by this, making the plate unstable. One trick that could help: Some strike plates have a recessed area on the back that helps them adhere to wood doors. ![]() Note: The strike plate should be able to fit in a metal door if it is correctly installed. You’ll need to drill pilot holes in the studs behind the drywall before you screw it into them from behind! Check out the full blog post below if you’d like to learn more! ![]() Your strike plate can now be attached to the wall by screws or nails, depending on your chosen type. You will then need to drill two holes for screws or nails at the top of the hole using an electric drill or hammer and chisel. This article will demonstrate how to install a strike plate on a metal door frame.īegin by measuring and marking the strike plate hole with a pencil. Two pieces make up the door frame side jambs that support the wall on either side and a header that supports any weight above. Doors with sliding glass doors and double-hung wood windows, as well as fire exit doors, can be supported by it. It is common to find metal door frames in homes and businesses.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |